Accordingly simulations using the 4th simulator, version 3 and using the kinetics module designed for magnetic simulators #4 (version 14), it was stated that the containment of the fusion particles reaches almost 100% during the establishment of the magnetic field.
This could help because increase confirmation time over 100 microseconds would allow reaching ignition conditions without enhancement methods (that could be added after).
The data exposed in the excel table were calculated using a two coil system, where it was used the expected confination time. Here are the simulations for only 40 particles in one of the proposed configurations:
It is simulated using a new kinetic simulator the Miranda reactor in configuration named 3N30x0945 using protons over 500 keV. It is stated a margin of the 35% over the energy range to confine the particles. The Larmor radius will be under 40% of the thin plasma chamber.
The first of them allows to calculate particle trajectories inside our reactors by using multiwire simulation of thick coils with exact result needed in order to allow compression of plasma using our EAC (Extreme Atomic plasma Compressors)
Also using elliptic integrals to have exact value of magnetic field it is designed a simulator subsystem that generate trayectories of particles to make kinetic diagnostic of accelerated plasma included speed and density over the 300 keV
The simulator will be used in the divertor design to eject particle debris after ignitions
A Magnet application is released in order to help calculations of the magnetic field inside reactors of the Liner class. Can be also used in Miranda reactors to help confine plasma before plasma heating in the 300KeV to 500keV region, divertor aparatus, plasma deflectors, electron deflectors, spin orientation, and electrokinetic compression
Advanced Ignition reactors will use clean reactions
The clean reactions are:
H+ Be9 -> Li6 + Alfa + 2.64MeV gain 528%
H + Li6 -> He4 + He3 + 4 MeV gain 800%
H+B11 -> 3 Alfa + 8.686MeV gain 12360%
Clean reactions are impossible to be performed using old electron heaters reactors as long as they radiates all the received energy with the 4TH power of the plasma energy and that reactions needs more than 350 keV that could not be reached in any reactor that heats thermally the plasma, as it was stated in our Pulsotron-2A reactor unless plasma density is lowered so much that very few reactions can be done as happened in the old reactors. So it was created new ion injection systems that allows to multiply ten times plasma energy by using ten times more power. Our reactor losses are in the range of a few hundred watts.
In the following figure appear the proton-beryllium reaction cross section. As larger the cross section is, more power can be extracted from the plasma.